Honda BF115A, BF130A Outboard Motors Shop Manual., Page 161Get this manual
HONDA BF115A-130A
FUEL PUMP FILTER
INSTALLATION: Install the filter suspension with the "4" mark on the filter toward the air vent tube A, and connect the tube11"MARK
AIR VENT TUBE SIDE
14 23 mm WASHER18 16 mm SPECIAL BOLT INTAKE MANIFOLD STAY A
INSTALLATION: Install the 14 23 washers as shown noting the installation directionBe sure that the shoulders of the 16 special bolts are through the washers and stay A's, and loosely tighten the special bolts
[I18 16 mm SPECIAL
[31 STAY A
Position the projection of the upper intake manifold stay in contact with the left side of the boss of the crankcase, and position the projection of the lower intake manifold stay in contact with the crankcase sealing boltThen, loosely tighten the respective 18 mm flange boltsTighten the 10 mrn cap nuts to the specified torque (P5-72), then tighten the 16 special bolts and the 18 flange bolts in the listed order securelyAfter tightening the bolts, be sure that the 16 special bolts do not set on the washers and the stay As