Honda BF115A, BF130A Outboard Motors Shop Manual., Page 71Get this manual
HONDA BF115A-130A
10SHIFT CABLE
Adjustment: 1) Move the remote control lever to the "N" (Neutral) position
111 SHIFT LINK
2) Themark on the shift link bracket should align with themark on the shift linkI'
If the marks are not in alignment, adjust as follows
3) To adjust, loosen the shift pivot lock nut, and remove the mm lock pin and mm washers from the shift pivot
Remove the shift pivot from the shift link, and adjust by turning the shift pivot in or out4) Set the shift pivot on the shift linkThe" mark on the shift link bracket should align with the" mark on the shift linkTighten the lock nut
6 rnm LOCK PIN
5) Check whether the detent spring roller is in the shift arm groove ["N" (Neutral) position] with the" mark on the shift link bracket in alignment with the" mark on the shift link(The shift arm end should align with the neutral switch end