2001-2014 Honda BF/BFP8D, BF/BFP9.9D Outboards Shop Manual, Page 367Get this manual
BF8D-BF9.9D bINSTALLATION
Installation is the reverse order of removal Route the power tilt switch wire along the main wire harness Wrap the wires with the lower spiral protector (shorter) starting from the branch point of the main wire harness as shownCover the motor and switch wire with the corrugated protector and set it in the place as shownSecure the wires covered with the spiral protector with the wire clamp (two places) and wire band clip (one place)Secure the power tilt switch and motor wire with the wire band clip at the center of the marking tape points as shownCORRUGATED PROTECTOR Set the corrugated protector so that its end is approximately mm (0.2 in) above the end of the connector bracket BSPIRAL PROTECTOR Put the spiral protector to the power tilt relay mount rubber as shown