2001-2014 Honda BF/BFP8D, BF/BFP9.9D Outboards Shop Manual, Page 355Get this manual
BF80-BF9.90 16) Apply ATF to new O-ring, and install it on the power tilt motor assembly17) Install the oil tank on the power tilt motor assembly so that the oil hole cap bolt mounting hole is at the motor wire side18)Set the wire band clip on the clip bracket, and secure the motor wire19)Tighten the two socket bolts to the specified torqueTORQUE: 4.4 Nm (0.45 kgfm, 3.3Ibfft)
SOCKET BOLT (2)
CLIP BRACKET
eATF FILLING
1) Using syringe or equivalent tool, add approximately 30 cm (1 .01 US oz, 1.06 Imp oz) of ATF slowly through the oil filler port of the oil tank2) After adding ATF, tighten the manual valve securely Wipe up any spilled ATF thoroughly Be sure that the oil hole cap bolt is not tightened3) Connect fully charged battery, power tilt relay and power tilt switch to the motor so that the power tilt assembly can be operated 4) To bleed the air, lean the power tilt assembly to the left, viewed from the oil filler port side, several times slowly at an angle of 10 to 30 as shown 0