2001-2014 Honda BF/BFP8D, BF/BFP9.9D Outboards Shop Manual, Page 275Get this manual
BFBOeBFS.SO bINSPECTION IGNITION CONTROL MODULE
Measure the resistance between the terminals and be sure that the measurements conform to the ranges shown in the table below Use tester that is equivalent to or higher than the performance specifiedInternal resistance: 20 kflNDC, kON AC Be careful not to touch the metallic part of the tester probe with your body, otherwise correct resistance value cannot be obtained Read the tester manufacturer's operation instructions carefully before operation with testerFollow the instructions of the Service ManualBe sure the tester's battery is fully charged and check the meter before using the testerUse scale of an commecially available multi meter, and meter shows current flow from negative to positive (+) If the meter shows current flowing one way and not other the diode is good 10 11 12 13 14 15 16