2001-2014 Honda BF/BFP8D, BF/BFP9.9D Outboards Shop Manual, Page 263Get this manual
BFBC-BF9.9C 1) Apply grease to the armature shaft, bearing and seal lip of the front bracket, and sliding surface of the overrunning clutch2) Install the front bracket onto the armature 3) Install the overrunning clutch, washer, return spring and pinion stopper4) Hold the armature upright and push down the pinion stopper using an offset wrench or spanner and install the 14 mm lock ring
PINION STOPPER
RETURN SPRING WASHER -
OVERRUNNING CLUTCH FRONT BRACKET
ARMATURE
5) Make sure that the seal ring is in good condition, replace if necessary, Install the seal ring onto the yoke Set the seal ring onto the stepped section of the yoke properly taking care not to pinch with the yoke and front bracket 6) Make sure that there is no obstruction on the magnetsInstall the yoke noting the installation direction as shown and align the index mark on the yoke with the index mark on the front bracket