2001-2014 Honda BF/BFP8D, BF/BFP9.9D Outboards Shop Manual, Page 139Get this manual
BFBO-BFS.SC 12) Install the bracket with the 14 mm flange bolt, and then insta ll the ignition control module and connector bracket using the two 25 mm flange bolts 13) Connect the pulse generator wire and power coil wire connectors and set them to the connector bracket
CONNECTOR BRACKET BRACKET IGNITION CON TROL MODULE
WIRE BANDS
14) Apply grease to the pivot of the throttle lever and connect the throttle cable linkage pivot to the carburetor throttle lever15) Place the throttle cable holder by aligning the flange to the space of the rib and mounting boss, and tighten the 14 mm flange bolt16) Set the starter case in the place and connect the drain tube to the starter case