2001-2014 Honda BF/BFP8D, BF/BFP9.9D Outboards Shop Manual, Page 76Get this manual
BFBOBF9.90 5) Apply marine grease to the water seal lips6) Install the reverse bevel gear to the ball bearing inner race of the propeller shaft holder7) Install the thrust washer onto the propeller shaft, then install them into the propeller shaft holder8) Install the shift sliderPROPELLER SHAFT HOLDER REVERSE BEVEL GEAR
hINSTALLATION
1) Install new a-ring to the propeller shaft holder2) Apply marine grease to the a-ring and mating surfaces of the propeller shaft holder and gear case 3) Install the propeller shaft holder assembly to the gear case and tighten the two 20 mm flange bolts to the specified torqueTORQUE: 12 Nm (1.2 kgfm, 9Ibf.ft) MARINE GREASE