Chrysler 75 and 85 HP Outboards Service Manual OB 3646, Page 179Get this manual
Reassembly and Shimming1Press bearing cup in gear housing, using cup installer (Special Tool NoT 11204) and driver handle (Special Tool NoT 8907)and guide plate from bearing guide set (Special Tool NoT 11209)Figure 29 GUIDE PLATE (T 11209)
DRIVER HANDLE (T 8907)
CUP INSTALLER (T 11204)
BEARING CUP
Figure 27Installing Propeller Shaft Seal14Check condition of lower driveshaft bearingIf bearing is not in good condition, replace by using Special Tool NoT 11205 bearing installerremover and 11209 bearing guide plate Drive old bearing completely thru bore and drive new bearing in until the top of it is flush with top lip of its boreFigure 28
Figure 29Installing Front Bearing Cup