Chrysler 75 and 85 HP Outboards Service Manual OB 3646, Page 176Get this manual
Figure 19Removing Propeller Shaft Seal From Spool APlace blade of screwdriver on end of retaining ring which has beveled cut-out Figure 17Removing Bearing Spool Screws
BTap handle of screwdriver with hand release retaining rings from groove in gear housing 18Remove bearing cage assembly as follows:
AInstall prop shaft bearing spool in gear housing (with O-ring seals removed) BSecure spool to bearing cage with two (2) screws C.lnstall puller (Special Tool NoT 8948-1) Figure
Figure 18Installing Puller
14Shift unit into either forward or reverse gear and turn driveshaft so that the puller unthreads itself from the prop shaftThis pulls the spool out of the gear housing 15 Remove O-ring seals from propeller shaft spool16Remove propeller shaft seal from spool using spring pin punch (Special Tool NoT 8919)Figure 1917Remove two (2) retaining rings from gear