Chrysler 75 and 85 HP Outboards Service Manual OB 3646, Page 137Get this manual

Chrysler 75 and 85 HP Outboards Service Manual OB 3646, Page 137

NOTE PIN

Th re are indentations at one end of compressorPlace these on top of cylinder to prevent compressor from entering cylinderClnsert piston in cyl inder bore
CONNECTING R

Position pis ton so that intake baffle faces toward intake port side of cylinderFigure 40 DTighten ring compressor until piston and ring can enter cylinder bore Push piston into bore with thumb pressure
CAUTION
-GUIDE PIN

Lack of ring compression can damage piston Figure 41
Figure 38Installing Piston Pin
TOP OF PISTON

PISTON RI (CROSS SE

Figure 39Piston RingPosition10Install pistonrings on piston with bevel on inner edge of ring facing upFigure 39Use ring expander Special Tool NoT 8926 11 Install piston in cylinder bore as follows :

Back to Chrysler 75 and 85 HP Outboards Service Manual OB 3646