Chrysler 75 and 85 HP Outboards Service Manual OB 3646, Page 119Get this manual
CHOKE SOLENOID RemovalFigure 26
1Remove hex nut securing green wire to terminal post of choke solenoid2Remove two (2) hex head screws securing solenoid to bracket and remove clamp Remove choke solenoid by pulling it away from plunger3Remove band securing wire to solenoid Testing and RepairEquipment: Ohmmeter (R Scale)
1Place positive test lead on terminal of solenoid
Figure 27Positioning Choke SolenoidDSecure solenoid with two (2) screws Figure 27ECheck choke operation by pushing down on plunger with screwdriver until it bottoms in the solenoid The choke shutter should only be open enough to allow the paper to be pulled outFigure 28 If not, reposition solenoid and recheck
Figure 26Removing Choke Solenoid
Place negative lead on solenoid caseMeter should indicate 0.51.35 ohms If notpart is defective and must be replacedInstallation