Chrysler 75 and 85 HP Outboards Service Manual OB 3646, Page 118Get this manual
Installation NOTE
Ends of interlock switch are differentUpper end has two slots and the tab has sharper bend Figure 231Connect yellow (shorter) lead to bottom terminal; and yellowblack stripe (longer) lead to upper terminalFigure 232Install switch to bracket and secure with two (2) screwsFigure 23
Figure 24Removing Starter RelayInstallation
1Place (double) black ground wire under head of forward attaching screw2Install starter relay and secure to support plate with two (2) screws 3Connect three (3) leadsstarter cable and battery cable to starter relay as follows: Figure 25
AConnect (single) black ground fead to inner terminalFigure 23Installing Interlock Switch
STARTER RELAY
Removal
WARNING
Always disconnect battery when working on engine 1Disconnect battery2Remove two (2) larger hex nuts and remove starter cablebattery cable and one lead wire 3Remove two (2) smaller hex nuts and remove two (2) leads4Remove two (2) screws securing starter relay to support plate and remove one lead wire5Remove starter relay Testing and RepairEquipment: Ohmeter (use Scale)