Chrysler 75 and 85 HP Outboards Service Manual OB 3646, Page 88Get this manual
NOTE Wires may have to be cut off clean to seat on contactsBInsert lead wire ends in cap against pointed contacts
Be sure screw holes and vents are lined up againC Draw distributor cover against cap by tightening two (2) screws until they bottom out 3Test each lead wire continuity as follows:
ASet up test lightSpecial Tool No 2938- 1Figure 40
Figure 41Installing Distributor Shaft
CInstall large plain washer, small plain washer and spacer on pulley end of distributor shaftFigure 41LIGHT
5Install shims and retaining ring as follows :
Figure 40Testing Lead Wire Continuity
AInstall woodruff key in slot on pulley en of
distributor shaftInstall pulley on end of shaftBClamp pulley in vise