Chrysler 75 and 85 HP Outboards Service Manual OB 3646, Page 85Get this manual
DISTRIBUTOR GeneralThe distributor used on the cylinder Chrysler Outboard Motor is "breakerless preamplifier (a switching device containing light emitting diode and light sensitive switch) replaces the breaker pointsA cup with three (3) equally spaced windows is attached to the rotorAs the distributor shaft rotates, the windows in the rotor cup allow the light emitting diode to rigger the light sensitive switch which signals the C-D unitRemoval
Bbracket
ground lead and lead to coil at
CRemove two (2) bolts securing bracket to power headDSlip distributor belt off pulley and remove brack et with housing
WARNING
Disconnect battery1Remove distributor cap assembly (base, seal, cover) as follows :
ADisconnect high tension lead wire from ignition
coil by pulling boot away from coil, then pulling lead wire from coilFigure 18
Mark or tag wires so they can be installed correctlyBRemove spark plug lead wires from spark plugsCLoosen two (2) screws on distributor cap retaining clipsFigure 30 DPull distributor cap assembly off housingFigure 31Removing Distributor Bracket with Housing