Chrysler 75 and 85 HP Outboards Service Manual OB 3646, Page 53Get this manual
CConnect small hook end of return spring on drive pin of carburetor and turn choke shaft counterclockwise until slot is in position to install choke shutter Dlnstall choke shutter through slot in choke shaft and secure with two (2) screws 4Install inlet needle and seat as follows: AInstall gasket on inlet needle seatBInstall inlet needle seat with gasket in carburetor and tighten securelyCInstall inlet needle5Install main fuel jet6Install float as follows:
133264 (10.319 .397 mm)
APosition float in carburetorFigure 41
Groove pin has grooves at one (1) end of pin onlyBInstall groove pin as shown in Figure 41and drive groove pin in until grooves can not be seen
Figure 42Measuring Float Height