Chrysler 75 and 85 HP Outboards Service Manual OB 3646, Page 52Get this manual
AInstall return spring on throttle shaft with large end of hook on throttle shaft arm and install th rattle shaft with spri ng Fig re 37 NOTE
For next step, note that edge of shutter is angled and that there is mark stamped on one side Figure 39C Install shutter with cut out portion in first and marked side up (out)Figure 39 Slip shutter in through slot in throttle shaft
TOP EDGE (BEVEL)
MARKED SIDE (OUT)
Figure 37Installing ThrottleSpring PositionBConnect small hook end of spring on drive pin of carburetorTurn throttle shaft arm clockwise until part of shaft arm with smaller hole is at o'clock (Ab ou 1 turn of tension on return spring)Fig ure 38