Chrysler 70, 75 and 85 HP Outboard Motors Service Manual OB 3438, Page 179Get this manual
Reassembly and Shimming 1Press bearing cup in gear housingusing cup installer (Special Tool NoT 11204) and driver handle (Special Tool NoT 8907), and guide plate from bearing guide set (Special Tool NoT 11209) Figure 29
GUIDE PLATE (T 11209)
DRIVER HANDLE -; (T 8907)
CUP INSTALLER (T 11204)
Figure 27Installing Propeller Shaft Seal
13Check condition of lower driveshaft bearingIf bearing is not in good conditionreplace by using Special Tool NoT 11205 bearing installerremover and 11209 bearing guide plateDrive old bearing completely thru bore and drive new bearing in until the top of it is flush with top lip of its bore Figure 28
Figure 29Installing Front Bearing Cup
Bearing cone is replaced as part of front gear assembly onlyIf new bevel gear assembly is being installedprop shaft end float must be checked