Chrysler 70, 75 and 85 HP Outboard Motors Service Manual OB 3438, Page 165Get this manual
3Install remote control cable bushing and cap on support plate and secure with three (3) screws 4Install battery cable grommet and secure with one (1) screw5Install deflection stop with four (4) screws and lock washers6Install engine cover latch assembly as follows: Figure 37APlace one bearing in each side of shaft bore in support plate BSecure handle to shaft with spring pin and inset handle into support plate CPlace spacer, then wavy washer on shaftFigure 36Removing Latch Assembly
DSecure cam to end of shaft with washer, slotted lockwasher and cap screw
2Remove deflection stop by removing four (4) screws and lockwashers securing stop to support plate 3Remove battery cable grommet by removing screw holding grommet to support plate4Remove remote control cable bushing and cap by removing three (3) screws securing them to support plate5Remove starter relay from support plate by removing two (2) screws6Remove identification plate from support plate by driving out two (2) drive screws DisassemblyFront Motor Leg Cover