Chrysler 70, 75 and 85 HP Outboard Motors Service Manual OB 3438, Page 164Get this manual
BDrive out spring pin securing reverse lock pin to swivel bracketFigure 33CDrive reverse lock pin out of swivel bracket and remove reverse lock and spring Figure 33 GRemove handleshaft, plain washer, reverse lock arm, two (2) nyliner bearings and shaft bearing from swivel bracket 7Remove clamp screw as follows:
ARemove stud and foot by driving out spring pin
securing them to clamp screwFigure 35 BThread clamp screw from stern bracket
Figure 33Removing Reverse Lock
DRemove reverse lock link from reverse lock arm EDrive out spring pin securing reverse lock arm to reverse lock release handle and shaftFigure 34 FRemove cotter pin securing reverse lock release handle and shaft to swivel bracket Figure 34Figure 35Removing Clamp ScrewDisassemblyMotor Leg
1Remove idle exhaust boot by removing clamp securing idle exhaust boot to motor leg using hose clamp pliers Special Tool NoT 89002Remove upper water line as followsARemove two (2) screws securing water line bracket to motor leg BLift water line with bracket out of motor leg CSlide water line bracket off water lineDSlide seal grommet off water lineDisassemblySupport Plate