Chrysler 70, 75 and 85 HP Outboard Motors Service Manual OB 3438, Page 137Get this manual
NOTE There are indentations at one end of compressorPlace these on top of cylinder to prevent compressor from entering cylinder lnsert piston in cylinder bore
SHIM SPACERS
Position piston so that intake baffle faces toward intake port side of cylinderFigure 40
DTighten ring compressor until piston and rin gs can enter cylinder bore Push piston into bore with thumb pressure
CAUTION
Lack of ring compression can damage pistonFigure 41
Figure 38Installing Piston Pin
TOP OF PISTON BEVEL EDGE UP
PISTON RING (CROSS SECTION)
Figure 39Piston RingPosition10 Install piston rings on piston with bevel on inner