Chrysler 70, 75 and 85 HP Outboard Motors Service Manual OB 3438, Page 102Get this manual
2Disconnect stator leads at regulator rectifier3Remove stator by removing six (6) screws retaining stator to bearing cage Cleaning and InspectionUse brush or compressed air to clean the stator windings, poles and laminationsClean dirty pole laminations with No400 or finer sandpaperInspect for loose connections or burnt insulation at the point where the lead wires connect to poles 2Disconnect four (4) lead wires and one ground wire Figure 123Remove three (3) screws securing regulatorrectifier to power head
Wear safety glasses when compressed air
Cleaning and InspectionVisually inspect bak elite body for cranksCheck terminals for loosen ess and corrosionRemove corrosion with file or em ery cloth
WARNING
working with Installation1Install regulatorrectifier with three (3) screws 2Connect lead wires to regulator rectifierFigure 123Reconnect battery