Chrysler 70, 75 and 85 HP Outboard Motors Service Manual OB 3438, Page 99Get this manual
3With engine not running disconnect stator leads from regulator rectifier, connect ohm meter (low ohms scale) or 2938-1 continuity tester in series with statorIf tester lights or ohm reading is 0.51.0 ohms, stator is good TEST #4Testing regulator-rectifierEquipment: voltmeter VOLTMETER
+REDWHITE
This is not bench checkTest must be made with engine running 1Disconnect redwhite lead wire from battery side of starter relay 2Place jumper wire between end of redwhite lead (lead that was removed) and terminal it was removed from This is necessary to start engine Figure 4
CAPACITOR GROUND
UMPER WIRE
Figure 5Testing Regulator-Rectifier
TEST #5Checking circuit breakerEquipment 2938-1 continuity tester1Reset circuit breaker2Connect one lead to each terminal, light should come on
Figure 4Installing Jumper Wire
FLYWHEEL