Chrysler 70, 75 and 85 HP Outboard Motors Service Manual OB 3438, Page 93Get this manual
cracks Inspect lead wire for worn or cracked insu lation2Inspect studs and shock mounts for wear, cracking Installation 9Route red, white and blue lead wires up and over power headunder flywheel and down to termin al blockConnect leads to terminal block (as listed on decal on exhaust port cover)
Wires should be routed and dressed so that they will not get in contact with the flywheel
1Install three (3) shock mounts on power head and torque to 40 in Ibs(46 kg cm)
Positive terminal (+) on coil must be toward outside; ground terminal (GND) toward inside2Place coil on C-D unit, install coil clamp over coil and secure with three (3) screws3Place gray lead from C-D unit on positive terminal (+) on coilSecure with lockwasher and nutFigure 55 4Place black lead from C-D unit and black lead from distributor bracket to coil on ground terminal (GND) on ignition coil and secure with lockwasher and nut5Place C-D unit with ignition coil on studsInstall three (3) stop nuts and torque to 90 inIbs(105 kgcm)