Chrysler 70, 75 and 85 HP Outboard Motors Service Manual OB 3438, Page 88Get this manual
NOTE Wires may have to be cut off clean to seat on contactsBInsert lead wire ends in cap against pointed contactsLARGE WASHER SMALL SHER'
Be sure screw holes and vents are lined up againCDraw distributor cover against cap by tightening two (2) screws until they bottom out3Test each lead wire continuity as follows:
ASet up test lightSpecial Tool NoT 2938-1 Figure 40
Figure 41Installing Distributor Shaft
CInstall large plain washersmall plain washer and spacer on pulley end of distributor shaft Figure 41
5Install shims and retaining ring as follows :
Figure 40Testing Lead Wire Continuity
AInstall woodruff key in slot on pulley end of
distributor shaftInstall pulley on end of shaftBClamp pulley in vise