Chrysler 70, 75 and 85 HP Outboard Motors Service Manual OB 3438, Page 56Get this manual
BInstall choke link 4Install throttle linkage as followsASecure throttle tie bar to top and middle throttle arms with retaining ringsFigure 52 Figure 53Installing Choke Linkage, Bottom Carburetor
ASecure throttle tie bar to middle and bottom throttle arms with retaining ringsFigure 54
Figure 52Installing Throttle Linkage, Middle Carburetor
5Install carburetor intake, cover, three (3) gaskets with six (6) screws 6Reconnect two fuel lines7Adjust carburetors as outlined in this section
InstallationBottom Carburetor
1Apply sealant to threads of fuel inlet fitting Special Tool NoT 8955 Install fitting on carburetor with barb at 'clock 2Install carburetor on flange and secure with two (2) hex nuts 3Install choke linkage as follows APlace one O-ring on choke swivel and insert swivel through hole in lever of bottom carburetorPlace second O-ring then washer on end of swivel and secure with cotter pin Figure 53