Chrysler 70, 75 and 85 HP Outboard Motors Service Manual OB 3438, Page 47Get this manual
RemovalTop carburetor 1Remove carburetor intake with cover and three (3) gaskets by removing six (6) screws 2Disconnect throttle tie bar by removing two (2) retaining rings holding throttle tie bar to arms of top and middle carburetorFigure 20
Figure 21Disconnecting Choke Linkage
4Slide hose clamp down from inlet fitting on carburetorHose Clamp Pliers, Special Tool NOT 8900 Pull hose off, remove fitting5Remove two (2) hex nuts securing carburetor to carburetor adapter flange
Figure 20Disconnecting Throttle Tie Bar(Top and Middle Carburetors)RemovalMiddle Carburetor
1Remove carburetor intake with cover and three (3) gaskets by removing six (6) screws 3Disconnect choke linkage from choke shaft and lever as follows: 2Disconnect throttle tie bar by removing two (2) retaining rings holding bar to arms of top and middle carburetors Figure 203Disconnect choke linkage as followsALoosen all three (3) choke arm swivel screws and remove choke linkBRemove cotter pin securing choke swivel to middle leverFigure 22 CRemove washer, two (2) a-rings and swivel fro leverE u