Chrysler 70, 75 and 85 HP Outboard Motors Service Manual OB 3438, Page 19Get this manual
plug holeTurn engine over by hand several times to distribute the oilThis will lubricate the pistons, rings and cylinder walls and expel water from the cooling system Reinstall spark plugs5Drain and refill lower gear housing as outlined underLubrication Points6Lubricate all moving parts as outlined underLubrication Points "7Clean exterior of engine Apply marine-type wax to protect the finish and prevent rust or corrosion 8Remove propeller and apply coating of 2987-1 Anti-Seize Compound on propeller shaftReinstall propeller9Store engine in an upright position in dry, wellventilated area Preparation for Use After StorageTo prepare the motor for use after it has been in storage, proceed as follows1Remove spark plugsrequired Clean or replace as
owner's Registration Card for validityTune-ups are not covered under warranty Before going ahead with the tune-upcheck your service bullet in collection for possible changes and or tips that apply to this motorTune-Up Check ListCheck the motor visually for any obvious damageConsult the troubleshooting chart for aid in diagnosingBegin systematic tuneup procedure as follows :