Chrysler 6, 7.5, 180 Sailor Outboard Motors Service Manual, OB 3330, Page 133Get this manual
9Install propeller shaft bearing cage as follows: ACarefully guide cage on propeller shaftlightly tap around edge to seat in housing CAUTION
Avoid cutting O-ring when installing cage BApply sealant (special tool NoT8983) to screws and installTighten securely 10Install shift detent spring and detent pin in gear housing upper and secure with gear housing plugFigure 646.16" (15 .6 em)
Figure 65Adjusting Shift Rod
BTh read adapter of pressure tester (special tool NoT8950) in vent hole of gear housing and tighten securelyCPressurize housing to 10 p.s.iand observe gauge for one minuteIf pressure drops, immerse housing in water and repressurize to 10 p.s.iObserve for air bubbles Replace any seals seen to be leaking and retest