Chrysler 6, 7.5, 180 Sailor Outboard Motors Service Manual, OB 3330, Page 131Get this manual
SEAL NSTALLER-(T 2915)
Figure 59Installing Drlveshaft Seal
7Install shift rod seal in gear housingupper as follows:
AInstall shift rod seal using special tool NoTa957 Figure 57Measuring Pinion Shaft Height
cage Figure 58 Garter spring should face out toward rear of prop shaft and seal should bottom in bore
Install with raised bead on seal faCing upSeat in bore by driving down until seal is flush to .0 10 depressed below cavity surfaceFigure 60
SEAL INSTALLER (T 3431)
SEAL INSTALLER (T 8957)
Figure 58Installing Seal In Searing Cage