Chrysler 6, 7.5, 180 Sailor Outboard Motors Service Manual, OB 3330, Page 85Get this manual
with hole and turn in until head is bottomed against ropeWind rope in spool groove counterclockwise as viewed from top BApply light coat of lubricant (special tool NoT2961) to base of starter spoolPlace spool in lower starter bracket and route rope to starboard, side of interlock shaft and through eyelet in support plate CFeed rope through starter rope handle and retainerRoute rope in grooves of retainerPush retainer into handle4Install interlock shaft as follows:
T2961) to pinion spring groove and inner diameter of pinion gearInstall pinion spring in groove of pinion gear
Spring friction must not be excessive so as to cause sluggish recoil or severe bending of wire loop when interlock is engaged and starter handle is pulled outAdjust spring as necessary Install spring using sideways motion The open end of the spring must not exceed 2.01" (50 .825 mm) or spring may be overstressed CPlace pinion gear assembly on special shaft with loop on spring over boss on starter bracket7Install starter spring assembly as follows: