Chrysler 6, 7.5, 180 Sailor Outboard Motors Service Manual, OB 3330, Page 30Get this manual
Cleaning And InspectionInspect poppet and spring for obvious signs of damageInspect all parts for petroleum gum and varnish and clean with suitable solventReassemblyTo reassemble to coupler proceed as follows :
and install it in its groove using suitable tool (hooked piece of wire)
CAUTION
Be sure working end of wire is rounded off to prevent damage to new a-ring
To facilitate installation it may be necessary to use second piece of wire to push poppet down while positioning a-ring When properly installed the poppet will seat against the bottom a-ring providing seal4Place drop or two of oil on new top a- ring and position it in the remaining groove of the coupler