Chrysler 4 HP Outboard Motor Service Manual OB 2278, Page 49Get this manual
SECTION XI (Con't BApply sealant (Special Tool T8983) to threads of cylinder head screwsPlace spacers on top two (2) screws and install screws in cylinder headInstall bottom two (2) screws and torque all screws to 130 inch pounds4
REED 09-15 REED STOP
4-1Removing Reed and Reed Stop
ARemove reed plate assembly as outlined in Section XI, paragraph 3-IBRemove two (2) screws securing reed stop and reeds to reed plate(See figure 5
NOTE Retorque cylinder head bolts after 30 minutes of operationInstall spark plug and lead wire
DInstall fuel tank as outlined in Section VIII, paragraph 1-2EInstall engine cover-upper as outlined in Section IV, paragraph 1-23
REED PLATE ASSEMBLY 09-14 REED PLATE GASKET 09-16
3-1Removing Reed Plate Assembly and Gasket
ARemove carburetor complete as outlined in Section V, paragraph I-IBRemove reed plate assembly and gasket from studs on carburetor adapterFigure 5Removing Reeds and Reed Stops