Chrysler 4 HP Outboard Motor Service Manual OB 2278, Page 25Get this manual
SECTION VII (Con't 1-2Installing Fuel Tank
AApply Loctite (Special Tool T2962-1) to threads of fuel tank fittingInstall fitting and tighten securelyBPlace fuel tank on engineFUEL SHUT-OFF VALVE
2-1Removing Fuel Shut-off Valve
ARemove engine cover-upper as outlined in Section IV, paragraph 1-1BDrain fuel from fuel tank
Stator plate must be in same position for installing tank as it was when removing tankCInstall throttle lever and secure with lockwasher and screw
CRemove fuel tank as outlined in Section VII, paragraph 1-1
DUse hose clamp pliers to remove hose clamp from fuel shut-off valveUse fingers to push hose off fitting
DInstall two screws and lockwashers securing fuel tank rear to powerheadSee figure 4
EPull knob off fuel shut-off valveRemove shut-off valve from carburetor as shown in figure 5
Figure 4Location of Rear Mounting Screws
Figure 5Removing Fuel Shut-off Valve
EInstall two screws, lockwashers and spacers securing fuel tank legs to support plateSpacers go between fuel tank leg and support plateFInstall two screws and lockwashers se-