Chrysler 4 HP Outboard Motor Service Manual OB 2278, Page 21Get this manual
SECTION VI (Con't 4-2Installing Flywheel KeyAPlace key in slot on crankshaft
6-2Installing Breaker Point
APlace breaker point set on stator, install screw and washerDo not tighten screw at this time
BInstall flywheel as outlined in Section IV, paragraph 2-2MAGNETO CAM 03-16
ARemove flywheel as outlined in Section IV, paragraph 2-2
5-1Removing Magneto Cam
BSecure condenser lead, coil lead, ground lead and breaker spring to insulator on breaker setCAdjust breaker point as outlined in Section IV, paragraph 2-3DInstall flywheel as outlined in Section IV, paragraph 2-2
BRemove flywheel key and pull cam from crankshaft
5-2Installing Magneto Cam
AWith breaker point and wick positioned to clear cam, slip cam on crankshaft with lettered side facing upCONDENSER 03-14
ARemove flywheel as outlined in Section IV, paragraph 2-2BRemove screw and condenser lead from insulator on breaker setCRemove screw and clamp securing condenser to statorSee figure 4