Chrysler 25 and 30 HP Outboard Motors Service Manual OB 1894, Page 80Get this manual
SECTION XIV (Cont HAdjust throttle cam rod as outlined in Section IV, paragraph 3-11On electric start models, adjust
idle stop screw as outlined in Section IV, paragraph 3-2JOn electric start models, install
interlock switch as outlined in Section XI, paragraph 3-27TRANSFER PORT COVER 09-16 TRANSFER PORT COVER GASKET 09-17
7-1 Removing Transfer Port Cover and Gasket
FigurePosition of Long Screw in Transfer Port Cover
ARemove shift lever as outlined in Section XIV, paragraph 12-1BRemove ten (10) hex head screws securing transfer port cover to powerheadRemove transfer port cover and gasketCRemove fuel pump as outlined in Section VII, paragraph 2-17-2 Installing Transfer Port Cover and Gasket
AUnsnap throttle cam rod from throttle camBRemove carburetor as outlined in Section V, paragraph 1-1CRemove eight (8) screws securing adapter flange to powerheadRemove adapter flange and reed plate assemblyDSeparate adapter flange from reed plate assemblyERemove screws securing reed plates to deflector plateRemove reed plates and gasketFRemove lock nut securing throttle cam to adapter flangeRemove cam and bearingsGUse stud remover to remove carburetor and throttle cam studsNOTE