Chrysler 25 and 30 HP Outboard Motors Service Manual OB 1894, Page 71Get this manual
SECTION XIII (Cont HPosition rear retainer bracket so that upright part is aftSecure with two (2) screwsIPlace packing, mounts (slots down), then support plate on spacer platePlace mount (slots up) on support plate and secure with four (4) fastenersTorque fasteners to 125 inch poundsJInstall powerhead as outlined in Section XIV, paragraph 2-230SPACER PLATE 25-08-18, 30-08-12 SHOCK MOUNTS (UPPER) 25-08-24, 30-08-16
30-1 Removing Spacer Plate and Shock Mounts
CUse two (2) screws to secure bracket to shock mount (upper thrust)DPlace shock mounts (upper side) between kingpin plate and spacer plateUse nut, with washer underneath, to secure shock mounts to spacer plateTorque nuts to 160 inch poundsEOn 25 HPmodels, place shock mount tabs under bottom nut so that tab fills slot in kingpin plateTorque bottom nut to 160 inch poundsFReassemble engine as outlined in Section XIII, paragraph28-2, steps through (hand start) or paragraph 29-2, steps and (electric start)31KINGPIN MOUNTING PLATE (HAND START MODELS) 25-08-36 KI NGPI 25-08-37, 30-08-31