Chrysler 25 and 30 HP Outboard Motors Service Manual OB 1894, Page 70Get this manual
SECTION XIII (Cont collar and arm on shaftSecure arm on shaft with spring pinArm should point to starboard sideFUse nut to secure shorting switch to support plateGPosition throttle cable bracket so that upright part is aftSecure bracket to support plate with two (2) screwsHUse two (2) screws to secure shift cable clamp to boss of support plate1Screw fuel line bushing into support plateJInsert latch shaft in support
ing rear retainer bracket to support plateDRemove retaining ring from cover latch shaftRemove spring and latch shaftEUnscrew fuel line bushing from support plateFRemove two (2) screws securing shift cable clamp to support plateGRemove two (2) screws securing remote throttle cable bracket to support plateHRemove support plate cover from front of support plate1Remove throttle cable and shift cable grommetsJUse
plate from bottomPlace spring on shaft and secure with retaining ringKPosition rear retainer bracket
so that upright part is aftSecure with two (2) screwsLPlace packing, mounts (slots down)then support plate on spacer platePlace mount (slots up) on support plate and secure with four (4) fastenersTorque fasteners to 125 inch poundsMInsert magneto control shaft in grommet in support plateNInstall powerhead as outlined in Section XIV, paragraph 1-2SUPPORT PLATE (ELECTRIC START)