Chrysler 25 and 30 HP Outboard Motors Service Manual OB 1894, Page 67Get this manual
SECTION XIII (Cont KRemove tilt release lever and rod as outlined in Section XIII, paragraph 19-1LRemove tilt lock and tilt stop as outlined in Section XIII, paragraph 17-1 and 18-1MRemove stern brackets as outlined in Section XIII, paragraphs 15-1 and 16-1222 Installing Swivel Bracket and Bearings
KInstall magneto control shaft gear as outlined in Section XIII, paragraph 3-223CARRYING HANDLE 250812
231 Removing Carrying Handle
ARemove two (2) screws and lockwashers fastening friction plate to kingpin plateSlide plate to gain access to starboard carrying handle screwBRemove three (3) screws and lockwasherRemove carrying handle232 Installing Carrying Handle
AInstall stern brackets as outlined in Section XIII, paragraphs 15-2 and 16-2BInstall tilt lock and tilt stop as outlined in Section XIII, paragraphs 17-2 and 18-2CInstall reverse tilt release lever and rod as outlined in Section XIII, paragraph 19-2DInstall reverse lock as outlined in Section XIII, paragraph 21-2EInstall reverse lock spring as outlined in Section XIII, paragraph 20-2FInstall swivel bracket bearings in swivel bracketGSlide swivel bracket on kingpin with "0" ring (and spacer on 25 H.Pmodels)HPosition swivel bracket and kingpin plate assembly on engine and secure kingpin plate to shock mount (upper thrust) with two (2) hex head screwsIInstall shock mount covers as