Chrysler 25 and 30 HP Outboard Motors Service Manual OB 1894, Page 65Get this manual
SECTION XIII (Cont
Removing Rod from Reverse Tilt Lock Bracket
Removing everse Lock Spring
BConnect other end of rod to release leverCPosition release lever in swivel bracket with short spacer on starboard side of lever and long spacer on port side of leverDInstall stern bracket pivot bolt as outlined in Section XIII, paragraph 16-220REVERSE LOCK SPRING 25-08-33, 30-08-27
20-1 Removing Reverse Lock Spring
through eye of reverse lock spring with end of eye towards front of engineBDrive pin through reverse lock and install two (2) retaining ringsCPosition hook end of spring on hook of reverse lock adjusting couplingAdjust spring tension by turning coupler (see figure
ARemove two (2) retaining rings securing pin which retains reverse lock spring to reverse lockBLoosen jam nut from coupling on reverse lock spring adjusting linkage systemCTurn coupling to relieve tension of reverse lock spring as shown in figure 9Unhook spring from coupling hookDSlide pin on reverse lock out and remove spring20-2 Installing Reverse Lock Spring