Chrysler 25 and 30 HP Outboard Motors Service Manual OB 1894, Page 64Get this manual
SECTION XIII (Cont 17-2 Installing Tilt Lock
AInstall wavy washer under head of tilt lock pivot screwBInstall pivot screw with wavy washer through pivot hole of tilt lockHead of screw is on opposite side of bent tab on tilt lockCInstall nylon spacer then spring on pivot as shown in figure 7
screws on swivel bracket and stern bracketCRemove pivot wavy washer, and spacer from stern bracket (starboard)DRemove pivot screw and spacer from swivel bracket and remove tilt stop18-2 Installing Tilt Lock
AInstall wavy washer under head of pivot screwBInstall pivot screw with wavy washer through pivot hole of tilt stopCInstall nylon spacer on pivot screw and install this assembly on stern bracket (starboard)DInstall nylon spacer between tilt stop and swivel bracketInstall other pivot screw through slot in tilt stop and spacer and secure to swivel bracketFigure Tilt Lock Assembly
19REVERSE TILT RELEASE ROD REVERSE TILT RELEASE LEVER