Chrysler 25 and 30 HP Outboard Motors Service Manual OB 1894, Page 61Get this manual
SECTION XIII (Cont 9MOTOR LEG COVER (PORT, 25 H.P 08-19 MOTOR LEG COVER (STARBOARD, 25 08-20
9-1 Removing Motor Leg Covers
kingpin plate and spacer plate as shown in figure 5
ARemove five (5) screws and nuts securing motor legs togetherBRemove leg covers from motor leg being careful not to lose hex nuts in recesses of leg cover port9-2 Installing Motor Leg Covers
AInstall motor leg covers on motor legBSecure leg covers together by inserting screws from starboard side to hex nuts in recesses of leg coverportNOTE
Loosening Upper Side Shock Mount Nuts
EWith reverse lock engaged, pull motor leg back enough to allow motor leg cover (front) to slip down and then sideways10-2 Installing Motor Leg Covers
Three longest screws are positioned at top, rear corner and two forward positionsShortest screw is positioned at bottom rear corner10MOTOR LEG COVER (REAR, 30 H.P 08-14 MOTOR LEG COVER (FRONT, 30 H.P 08-13
10-1 Removing Motor Leg Covers