Chrysler 25 and 30 HP Outboard Motors Service Manual OB 1894, Page 59Get this manual
SECTION XIII (Cont paragraph 3-1BRemove two (2) screws securing bearing (rear) to support plateCSlide magneto control shaft back and out of support plateDSlide shaft shaft from shaft back until control link is horizontalPush forward and unhook link shaft
ERemove retainer, spring and bearing (rear) from magneto control shaft5-2 Installing Magneto Control Shaft and Bearing (Rear) Figure Removing Steering Handle Shaft Bearing
hole in shaftSupport shaft with suitable block and drive spring pin through throttle stop and shaftDInstall steering handle on kingpin mounting plateEInstall fiber washer on pivot boltFPlace retainer on pivot bolt and spring pin, then secure with stop nutGAdjust stop nut for desired frictionHInstall steering handle gear and bearing as outlined in Section XIII, paragraph 2-21Install magneto control shaft gear
AInstall bearing (rear), spring and retainer on shaftBInsert end of shaft in grommet and hook on linkThen insert shaft in bearing (front)CPosition bearing (rear) on support plate boss with rib on bearing up and part number forwardSecure bearing with two (2) screwsDInstall magneto control shaft gear as outlined in Section XIII, paragraph 3-26SHOCK MOUNT COVERS (25 H.P 08-23