Chrysler 25 and 30 HP Outboard Motors Service Manual OB 1894, Page 57Get this manual
SECTION XIII- MOTOR LEG 1STEERING HANDLE GRIP (HAND START
MODELS) 25-08-14, 30-08-38
1-1 Removing Steering Handle Grip
If fingers are insufficient for
ADrive out spring pin securing grip to steering handle shaftNOTE
removing bearing, protect bearing with washer before pushing with steering handle shaftShaft may bind if soft edge of bearing is damaged2-2 Installing Steering Handle Gear and Bearing
Steering handle grip must be supported or serious damage to components of steering handle or kingpin mounting plate may occurBSlide steering handle grip from steering handle and shaft1-2 Installing Steering Handle Grip
ALower steering handleInstall steering handle bearing with open side up and towards the rear (when handle is horizontal)See figure 1
ADrive spring pin in grip approximately 18 inch and install grip on steering handle and shaftBAlign spring pin holes of steering handle shaft and grip with flat on shaft 180 from "Start" position on gripDrive spring pin in to secure grip to shaft2STEERING HANDLE GEAR (HAND START MODELS) 25-08-16, 30-08-41 STEERING HANDLE BEARING 25-08-15, 30-08-40