Chrysler 25 and 30 HP Outboard Motors Service Manual OB 1894, Page 35Get this manual
SECTION VIII (Cont prevents damage to ends of clutch slots of propeller shaft when removing spring pin from clutch (see figure 15)
Figure 16 -Installing Clutch
DCompress clutch spring as shown in figure 16Align clutch so that spring pin does not contact either end of clutch slot in propeller shaftEDrive spring pin in clutch until it contacts shank of pin remover as shown in figure 16FRemove propeller shaft assem-
Figure 15 -
Removing Clutch
propeller shaft with clutch on vise (partially opened) covered with shop ragtoprevent scratching machined surfacespin remover (Special Tool T8919) drive spring pin out of clutch as shown in figure 15
bly from pin remover and install again, to exert pressure against spring pin to hold it away from edge of clutch slot in propeller shaftGDrive spring pin in until flush with sides of clutch