Chrysler 25 and 30 HP Outboard Motors Service Manual OB 1894, Page 33Get this manual
SECTION VIII (Cont ARemove gear housing upper as outlined in Section VIII, paragraph 12-1BPry seal from gear housing with small blade screwdriver15-2 Installing Shift Rod Seal
Bo Install gear housing-upper on gear housing-lower as outlined in Section VIII, paragraph 12-217BEVEL PINION 05-30
17-1 Removing Bevel Pinion
AApply Loctite "H" (Special Tool T2962) to outer diameter of sealBInstall seal on installer (Special Tool T8957) with raised bead on seal against shoulder of tool
ARemove lower unit as outlined in Section VIII, paragraph 1-1BRemove gear housing-upper as outlined in Section VIII, paragraph 12-1CRemove bevel gear- rear as outlined in Section VIII, paragraph 16-1DRemove propeller shaft assem-
CPress seal in seal bore located at bottom of gear housing-upper until it is flush with surfaceDInstall gear housing-upper as