Chrysler 25 and 30 HP Outboard Motors Service Manual OB 1894, Page 28Get this manual
SECTION VIII (Cont AInstall water pump back plate on gear housing upper by sliding plate down dri veshaftAlign screw holes in plate with holes in gear housingBInstall drive pin in hole in driveshaftCInstall impeller as outlined in Section VIII, paragraph 4-2DInstall water pump body assembly as outlined in Section VIII, paragraph 3-26INLET WATER LINE SEAL 05-15
6-1 Removing Seal 7-1 Removing Seal
ARemove lower unit as outline in Section VIII, paragraph 1-1BRemove water pump body as outlined in Section VIII, paragraph 3-1CPry seal out of bore of pump body using screwdriver as shown in figure 4
ARemove lower unit as outlined in Section VIII, paragraph 1-1BDepress tabs on seal as shown in figure and pull seal from water pump bodyFigure em oving Pump Body Driveshaft Seal