Chrysler 25 and 30 HP Outboard Motors Service Manual OB 1894, Page 27Get this manual
SECTION VIII (Cont ment between coupler and lower shift rod for shift adjustmentHThread coupler on shift rods until shift knob on support plate is centered in NEUTRAL position (knob in vertical position)1Tighten jam nut against couplerJInstall motor leg covers as out-
BInstall impeller in water pump bodySlotted end of impeller bushing must face back plateCSlide water pump body assembly
down driveshaft and line up slot of impeller with drive pin in drive shaftDApply Anti-Seize (Special Tool T2987-1) to water pump body screws and secure water pump body to gear housing upperEInstall lower unit as outlined in Section VIII, paragraph 1-24WATER PUMP IMPELLER 05-14
4-1 Removing Impeller
lined in Section XIII, paragraph 9-22GEAR SHIFT ROD LOWER) 05-19
2-1 Removing Shift Rod Lower
ARemove lower unit from engine as outlined in Section VIII, paragraph 1-1BRemove shift rod by turning counterclockwise un til rod threads out of shift camCPull shift rod out slowly to pre-
ARemove water pump body as outlined in Section VIII, paragraph