Chrysler 20 and 30 HP Outboard Motors Service Manual OB 3435, Page 128Get this manual
ARemove rewind spring from housing Figure 5BRemove interlock lever by driving out spring pin Figure 5 ANew Spring: Leave retainer on new spring and go to Step DOld Spring: Start with next step
Figure 5Disassembling Housing
CRemove housing liner by removing screwFigure 5DRemove housing strap by removing screw 3On hand start models, remove handle guide and spring from rope outlet boss of housing
Figure 6Assembling Housing
BGrease springSpecial Tool NoT 2961 CClamp pin punch in vise and hook center end of spring over pin Wind spring into coil small enough to fit in starter housing DPlace spring in starter housing with outer end over spring retaining bossso that spring runs counterclockwise from retaining boss Figure 53Install rope and pulley as follows :
Inspection and Repair
1Clean all metal parts in an approved solvent2Clean interlock lever with mild soapy water3Check all parts for wear, damage4Check rope for frayed or weak areas