Chrysler 20 and 30 HP Outboard Motors Service Manual OB 3435, Page 121Get this manual
DInsert front bearing in bore in kingpin mounting plate and install shaft through bearing BInsert end of shaft through forward end of steering handleCSlide shaft bearing (flange end last) and throttle stop (spring pin hole last) onto shaftDInsert shaft through gear end of handle
ESecure rear bearing to boss in support plate with two (2) screws FInstall magneto control shaft gear so that face of gear is flush with end of shaftFigure 9Secure gear by torquing screw to 70 in Ibs(80 kg cm)
CAUTION
In next step, support throttle stop to avoid damageESecure throttle stop to shaft with spring pin Figure 11 FSeat shaft bearing into bore Glnstall steering handle gear bearing around end of shaft and into bore in handle so that open port of bearing is face down Figure 11
Figure 9Installing Magneto Control Shaft Gear and Bearing